Comdial and FXT Dokumentacja Pobierz pdf (Strona 118)

Users cannot mark a line during a conference call or when they are DISA callers. When users mark a line

during an active call, the system records the mark for the active line. If users take marking action during an idle

condition, the system records the mark for the last active line (this includes lines that are presently on hold).

System users can use the line disable feature at the installer’s station to restore service on the out of service line.

installers can restore service to individual disabled lines or they can take action to restore service to all marked

lines in the system if they wish.

Master Clearing The System

When master clearing the system, the installer can set the parameters to one of three settings.

Mode 1—"Key-Like Mode"

At default, assigns line appearances for every multiline telephone but does not assign group intercoms in

any station hunt list.

Mode 2—"PBX-Like Mode"

At default, assigns no line appearances but does default one unique group intercom appearances for every

multiline telephone in the hunt list.

Mode 3—"All-clear"

This option defaults the system with no button mapping, group intercom access, or extension numbers for

stations.

Maximum Call Duration

This feature automatically cuts off calls on certain lines after a preprogrammed time. The system will not cut off

calls made to an emergency number. The system sounds a warning tone at the busy station 10 seconds before it

disconnects the call. The warning tone consists of one 800 ms burst followed by eight 100 ms bursts.

Meet-Me Answer Page

Any station user can dial a code in response to an all-call or zone page and be connected to the paging party in a

private conversation.

Memory Retention Without Batteries

The database programming is electronically protected during AC power failures by an internal electronic

component sometimes known as a “supercap.” The stored data will remain in memory for a minimum of 65

hours provided that the system has been powered continuously for approximately 30 minutes prior to the power

failure or disconnection. The system clock will continue to run for at least 30 minutes after an AC power failure

or disconnection.

6 – 64 General Description

GCA40–215 General Description

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 161 162

Brak uwag

Comdial and FXT Dokumentacja Strona 118