Comdial FX Series Dokumentacja Pobierz pdf (Strona 188)

VMMI Programming Exercises

Printed in the USA Page 1 GCA39-082 Rev 2, Issue 9/01

Exercise 1: Establishing a Direct Connection

Pre-Setup Discussion

In this exercise, you will:

• Connect a PC to the phone system.

• Establish a connection in VMMI.

• Master clear the system.

• Set the system clock.

Programming with a PC

One of the ways to program the DXP, DXP Plus, FX96, FXT, FXS, and FXII is to connect a

computer directly to the system using a modular telephone line cord and adapter for the 9-pin

serial port on the computer. You can then log in and make changes to the software that controls

functions in the system.

The adapter connects the typical 4 or 6-pin line cord to the 9-pin COM port on the computer.

The other end of the line cord can plug into a standard 6-pin telephone jack located on the CPU

board of the telephone system. These jacks are also referred to as COM ports. The result is a

serial data link (path) between the computer and the DXP.

To log in, open the VMMI software on your computer and select Switch / Connect to from the

main menu at the top of the screen. At the next screen, select Direct Connection / Com Port 1

(typical) / Baud Rate 9600 / Data Bits 8 / Stop Bits 1 / Parity None.

Next you have to enter the password and click on Connect.

Comdial specifically recommends Master Clear and Setting the Clock as standard procedures

you should perform on every new system.

• The Master Clear assures that only the standard default information is in the system, and it

eliminates any residual information left from the manufacturing process.

• Setting the clock is a logical event that should be done so that reports and displays in the

system will show the correct time.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 251 252

Brak uwag

Comdial FX Series Dokumentacja Strona 188